Penerapan Metode Just In Time Pada Proses Perakitan Raket Nyamuk di PT.X
| Authors | ||
| Issue | Vol 3 No 2 (2020): Talenta Conference Series: Energy and Engineering (EE) | |
| Section | Articles | |
| Section |
Copyright (c) 2020 Talenta Conference Series: Energy and Engineering (EE)  This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License. |
|
| Galley | ||
| DOI: | https://doi.org/10.32734/ee.v3i2.1040 | |
| Keywords: | JIT (Just In Time) Push and Pull System | |
| Published | 2020-11-30 |
Abstract
Just in time merupakan kombinasi beberapa kegiatan untuk menghasikan volume yang tinggi dalam proses produksi dengan menerapkan minimal persediaan untuk bahan baku, work in process, dan produk jadi.[1] Penelitian ini dilakukan di PT. X yang memproduksi raket nyamuk, penelitian ni bertujuan untuk memahami dan mempersiapkan pra kanban, melakukan pengujian keabsahan data terhadap data waktu perakitan produk, menghitung jumlah kartu kanban yang diperlukan, dan merancang sistem Kanban. Dalam penelitian ini peneliti melakukan observasi pada objek yang akan diteleti. Penelitian ini menggunakan analisis data deskriptif kuantitatif sebagaiteknik analisisnya. PT. X masih menerapkan metode tradisional sehingga dalam proses perakitan raket nyamuk yang dilakukan masih terdapat kesalahan pada setiap work center, sehingga penelitian ini menerapkan sistem kanban yang digunakan untuk melihat frekuensi kesalahan dalam work center dan setelah di lakukan penelitian bahwa frekuensi kesalahan masih dalam batas yang dapat di terima.
Just in time is a combination of several design activities to produce high volume production by applying a minimum inventory for raw materials, work in process, and finished products. [1] This research was conducted at PT. X, which manufactures mosquito rackets, this research aims to understand and prepare pre-kanban, test the validity of data on product assembly time data, count the number of kanban cards needed, and design the Kanban system. Data collection techniques in this study is to make observations on the research object. This study uses quantitative descriptive data analysis as an analysis technique. PT. X still applies the traditional method so that in the process of assembling mosquito rackets, there are still errors in each work center, so this study applies the kanban system that is used to see the frequency of errors in the work center and after conducting research that the frequency of errors is still within the limits that can be accept.
